Which faults of tensile testing machine need to contact the manufacturer?
Which faults of tensile testing machine need to contact the manufacturer ? As a large , diverse functional device--Tensile testing machine , generally at the factory before shipment quality inspection will be carried out , but not a hundred percent sure there exists an error or a fault occurs , then what problems arise in the test, the user is needed ontact the factory , so the manufacturers to deal with it:
1. when the card is damaged, contact the manufacturer to replace .
2. the test system prompt enter the registration code , software testing parts of the system data loss, virus software, garbled or need the software to add new features
3. sensors, force calibration values ??when needed
4. overload during use , the sensor was damaged
If we use the equipment more than four questions can contact the manufacturer to find , come to understand the following routine maintenance under tensile testing machine :
1. the control thermostat timers and other ministries Table ﹑ functional parts on the panel, to prevent drowning , local or dust spilled oil off a lot of places together or corrosive vapors or gases and other places set up outside the house and prolonged exposure to sunlight direct local use .
2. the compressor and switching the power switch , the switch can not be continuous in a short time more preferably 5 minutes or longer , otherwise the compressor is easy to freeze damage .
3. during the test , when the test chamber door must be opened first turn off the power , to avoid danger.
4. if used continuously for a long time , or open the test chamber doors , the test chamber will produce frost , frost must be removed before the test .
5. when the test is completed , be sure to turn off the power and remove the frost , avoid water freezing , impact tests.
6. regularly wipe the device , arranged custodian responsibilities , as there can not be resolved , please contact the manufacturer for an exception to exclude .
7. the correct use of equipment in accordance with operating instructions .
Tensile testing machine which faults need to contact the manufacturer ? If you encounter the above four questions can contact the manufacturers bought also welcome to call us and we
will solve the problem for you to reduce unnecessary economic losses.
